Mission Control Simulation

ROAMTHINKER / SOFTWARE SHOWCASE

Mission Control Simulation

The interface hosted by Recon Rover’s main ESP32, adapted for you to explore. Telemetry and coordinates are simulated. Controls only change this demo; nothing connects to or moves a real rover.

Connecting

Waiting for rover status

GNSS accuracy—

Heading—

Waypoint / distance—

Forward LiDAR—

Preparing simulated telemetry…

Build a mission

Build and save a demo plan, then simulate running it. Saving never starts the demo.

Mission nameMission type

Waypoints up to 12

Paste a coordinate list

One latitude, longitude pair per line

Survey photos per stop

Patrol round trips0 repeats until you stop it.

Hold duration (seconds)0 listens until you stop it.

Automatic spotlight throughout this mission

Adapts while driving and waiting. A manual light change overrides AUTO until you re-enable it or start another mission.

Home position

Home source

Home latitude

Home longitude

Editing this form does not change a running mission.

Heading & readiness

Checking saved calibration…

Stops any current activity. Enables fresh data and saved-heading restoration.
For first-time setup, point the stopped rover in a known true compass direction.
Set its bearing, then turn the rover 45–135° to a second known bearing and verify.

True bearing (0–359.999°)

Recheck calibration if the sensor platform shifts. GPS travel needs a good outdoor fix, heading verification, and clear LiDAR coverage. HOLD works without a GPS fix.

Lights, microphones & camera

Spotlight

Sound response

Listening missions enable microphones, direction finding, aiming and sound-triggered photos. Setup changes below stop the current mission.

Ready

iPhone hotspot setup · simulated

Preview the network setup flow using the fictional values below. No credentials are collected, saved, or transmitted.

Demo network nameDemo password

In the physical rover, this setup configures its boards. Here it only updates the simulated status.